Menu
Garage door sensors are a house type safety feature that is also required by law in most states today. Sensors function to automatically stop a door from closing on a person or object, preventing accidents and injuries. When they are working properly the sensors send out a steady green light, indicating that it is safe to go ahead and close the door. When the sensor light turns yellow or blinks, however, it indicates that there is something wrong in need of attention. In this guide, we provide a thorough explanation on why the garage door sensor is yellow (including troubleshooting information), and solutions to potential problems. With this information in hand homeowners will be able return things to make garage use safe and secure for all members of the family.
Before troubleshooting it is essential to understand the inner workings of garage door sensors:
Garage door sensors are usually installed on either side of the garage door and close to the floor. They shoot out an invisible beam of light running throughout the entire width while not visible to human eyes, on the face of it
When a garage door is coming down, sensors detect any obstacle or interruption in their light bank. Once an obstruction is discovered by them the sensors instruct the opener to stop and reverse movement of the door, preventing accidents or
damage.
If the garage door sensors are yellow light or blinking, this means that problems exist with the sensor system. Common causes may be:
If the sensors strike a person or object other than themselves, (sensor activated will beep no be an honored status nor error reporting,) their beams will stop and the Yellow light will flash; or so that the lights of both sensor does not stay lit at any time when turned vertically 1 in away from facing each other.
The lens in sensor can be jammed by a foreign body, such as dirt or other material. This interferes with sensor's beam of light; the sensors may detect the possibility of an object's obstruction and upon (open close control same); do not see it function normally, thus causing yellow light to shine.
Sensor operation might be disturbed by faulty installation of wiring and connections or crosstalk among surround systems. You could find this could lead to yellow light instead caused by these areas.
Strong sunlight directly shining on the sensor lenses will interfere with them and result in yellow light.
In some cases, one or both sensors may not be working normally and demand attention. In the flashlights and status readouts, yellow lights indicate three possible malfunctions.
To discover and resolve the reason behind the yellow light from the garage door sensor follow these troubleshooting steps:
Use a soft, dry cloth to gently clean the sensor lenses. You must not use any surface cleaner. That will make scratches on the surface of the lenses and light cannot pass through or reflect anymore.
Always avoid harsh chemicals or abrasive materials to clean the lenses. You should dry your eyes and go back in a moment without touching them.
Check that wiring connections are tight and free of damage at both the sensors and the opener unit.
Tighten any loose connections and replace any damaged wiring connections or connectors.
Move any electronic devices or sources of interference away from the garage door opener and sensor area.
Test the sensors again to see if yellow light remains.
Install sun shields or shades to protect sensor lenses from direct light, especially during peak hours when the sun is at its highest point in the sky.
If the troubleshooting steps above do not resolve the issue, it may be necessary to incur the cost of changing one or both sensors.
© Copyright 2024 Dooracle and Affordable Garage Door Repair, All Rights Reserved